Baby Change Station Installation
Many times I have thought about installing a Baby Change Station in the Laundromat Restroom but I was usually at another store and that’s about as far as it got.
After a recent discussion, I decided it was time to make it happen.
I headed to Amazon and ordered on that was there in a couple of days. Inside the box, on the box, in the instructions and anywhere else you can think of are disclaimers about proper installation. I will add my own as well that this video shows the steps and tools I used but I am not endorsing nor saying this is the right or best way to install this piece of equipment.
That being said it wasn’t that hard of a job with the right tools. I had a block wall to mount it to which, although a little more difficult and you need a hammer drill, provides a very solid attachment.
Here is the link to the one that I bought and a couple of options.
The video steps through a few of the key points.
As I mentioned I put this into a block wall. Inside the box is a full-size template that you attach to the wall to locate the bolt holes.
Once the holes were in I used a Heavy Duty anchor that I bought a big box hardware store.
This type is pretty easy to use and based on the rating I felt it would hold the load.
Once the mounting bracket is installed it’s just a few more steps and it’s done.
Hope this helps.
Ken
P.S. As I mentioned many times this is only a suggestion and please use your own knowledge and judgment and hire a professional if needed.